EPSON Stylus Pro 9000
REMOVING THE CARRIAGE HOME POSITION SENSOR AND
ENCODER
Preparation:
Remove the Maintenance Cover as described in
Removal
on page 58.
Remove the Top Cover as described in
1. Disconnect the cables from CN2 (Encoder) and CN4 (HP Sensor) on the
carriage circuit board.
Figure 4-43. Disconnecting the Cables
Disassembly & Assembly
Maintenance Cover
Top Cover Removal
on page 59.
2. Remove the two screws (CP(W2) M3x6) securing the circuit board
mounting frame to the carriage assembly.
Screw
Figure 4-44. Removing the Circuit Board Mounting Frame Screws
Screw
82