Confirming The Tube Guide Assembly Position - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000
13. Secure the dark-colored ink tubes and ferrite core to the cable connection
plate with the plastic insulation lock (KI-100M).
Insulation lock (KI-100M)
NOTE: At this point in re-assembly, the tube guide assembly (tube guide,
FFCs, and protective film) is attached to the cable connection plate
with the cable support.
Disassembly & Assembly
Ferrite core

CONFIRMING THE TUBE GUIDE ASSEMBLY POSITION

1. Move the carriage all the way from one side to the other to make sure the
tube guide assemblies stay centered in the carriage path.
If any part of the tube guide assembly on the left moves laterally (towards
the front or back of the printer), loosen the ink pipe fixing side of the tube
guide fixing plate and CR cable pressing plate. Then adjust the tube guide
assembly so that it is centered, and secure the tube guide fixing plate and
CR cable fixing plate.
If any part of the tube guide assembly on the right moves laterally, loosen
the tube guide cover and CR cable fixing plate. Then adjust the tube guide
assembly so that it is centered, and secure the tube guide cover and CR
cable fixing plate.
2. Squeeze the FFC ferrite core and the cable support together, and secure
them with the plastic insulation lock (T18L).
3. Move the carriage to the left so that the left edge of the CR board is 43 mm
from the left-side frame. Make sure the ferrite core and cable support do
not touch the frame or screw. Also, make sure the FFC and protective film
do not touch or rub against the frame. If there is a problem, loosen the tube
guide fixing plates in the center and adjust the position of the edge of the
tube guide.
Make sure nothing touches the left-side
4. Attach the new CR board cover.
frame.
99