Epson Stylus Pro 9000 - Print Engine Service Manual page 74

EPSON Stylus Pro 9000
7. Using needle-nosed pliers, remove the Tension Spring.
Tension Spring
Figure 4-28. Printhead Tension Spring and Screw Removal
8. Remove the CB M3x6 screw, and then remove the printhead from the
carriage.
9. Remove the flat cable from the back of the printhead.
Disassembly & Assembly
10. Repeat steps 10 and 11 for the other printhead if necessary.
CB M3x6


When replacing the printheads, fold the flat cable behind
the printhead and make sure the printhead snaps fully into
place. When properly installed, the printhead ID is directly
behind and at the same height as the PG Cam Shaft. If the
PG Cam Shaft does not partially block the line of sight of
the printhead ID (when looking at the ID from straight in
front), the printhead is not installed properly.


When attaching the dampers to the printhead, follow the
same order, left to right, as shown on the control panel:
K, C, M, LC, LM, Y.
74