Epson Stylus Pro 9000 - Print Engine Service Manual page 87

EPSON Stylus Pro 9000
8. Remove the six screws (CP(W2) M2x4) securing the side cover of the I/H
assembly and remove the side cover.
9. Slightly rotate the I/C holder assembly so that the assembly is released
from the lock lever unit. Then remove the two screws (CP(W2) M3x6)
securing the friction gear assembly and remove the assembly.
Figure 4-53. Removing the side cover of I/H assembly
Disassembly & Assembly
Remove
Figure 4-54. Removing the friction gear assembly.
87