Bc Head Slant Adjustment (Head Height) - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

BC HEAD SLANT ADJUSTMENT (HEAD HEIGHT)

This function prints a check pattern that lets you adjust the vertical alignment of
Head C in relation to Head B. If the lines in the test pattern are not aligned, you
need to reposition Head C using the Head Adjust Lever shown in
1. Make sure "BC Head Slant" appears on the LCD, and press Enter.
2. Load a sheet of paper into the printer. The test pattern automatically prints.
3. Compare the printed pattern with the illustration below.

Press Enter if the adjustment is correct like the top row.

Otherwise, if the lines are staggered or uneven, open the front cover,
release the carriage lock by hand, and move the carriage away from
home position. Loosen the screw securing Head C, and move the
Head Adjust Lever left or right. Tighten the screw and then print
another test pattern to check the adjustment.
Light
Light
Cyan
Magenta
Adjustments
4. When done, make sure "BC Slant Check End" appears and press Enter.
Return the carriage to the capping position by hand and close the front
cover.
Figure 5-6.
OK
Bad
Printing Pattern
Check the pattern for offset lines
or segments and change the adjust
lever position if necessary.
BC Slant Check End
[SelecType]/[Paper Source]
Print Adj. Pattern
Head Adjust Lever
(to the right of Head C)
Figure 5-6. BC Slant Adjust Lever
[Enter]
End
adjustment/
next menu
120