Paper Configuration Menu; Cutter Replace Menu; Head Alignment Menu - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

PAPER CONFIGURATION MENU

The bold item is the default setting.
Table 1-8. Paper Configuration Menu
Message Item
PAPER NUMBER STD*
1
THICK. PAT PRINT
PAPER THICK 1
DRYING TIME 0MIN

CUTTER REPLACE MENU

Follow the order in Table 1-9
Table 1-9. Cutter Replacement Menu
Step Message
1 CUT. REPLACE
2 OPEN LOWER COVER
3 REPLACE CUTTER
4 CLOSER LOWER COVER
Printer Basics
Explanation
Select STD for Epson special paper
Select the appropriate number for thick
paper. Use the or to select the
registered number up to 4.
Prints a pattern to detect the paper
thickness. If PAPER NUMBER is set to
STD, the message does not appear.
If PAPER NUMBER is set to STD, the
message does not appear. Use the or to
select the registered number up to 17.
Determines the length of time the printer
allows the ink to dry. When printing on roll
paper, the printer will wait the specified time
after printing. Use the or to select the
registered number up to 30MIN.
to replace the cutter.
Item Explanation
EXEC. Prepare a replacement cutter
— Open the front cover
— Remove the old cutter and install
a new one
— Close the front cover. READY
appears on the display.

HEAD ALIGNMENT MENU

Table 1-10. Head Alignment Menu
Messages Item
ADJUST. PATT ALL
PAPER THICK STD
Explanation
Prints a full series of patterns. To print a
single pattern, use the and until the
registered pattern appears.
Leave on STD for EPSON paper. For other
media, use the and to select the
thickness in 0.1-mm increments.
16