Top Cover Removal - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

TOP COVER REMOVAL

Preparation: Remove the Maintenance Cover. See
Removal on page 58.
1. Remove the four screws, CP(W2) M4x12, that secure the left-side lower
mounting bracket (spindle holder) and remove the bracket. Repeat for the
right-side lower mounting bracket.
Mounting brackets
(lower)
Figure 4-4. Lower Mounting Bracket Removal
Disassembly & Assembly
Maintenance Cover
2. Remove the four screws securing the Top Cover to the printer.
CP(W2) M3x6 screws
Figure 4-5. Top Cover Removal
3. Lower the Paper Release Lever.
4. Slide the Top Cover slightly forward to free it from its mounting brackets in
back. Then lift the Top Cover from the rear, tilting it forward, and lift it away
from the printer.
When removing the Top Cover, avoiding catching its rear
edge on the Paper Thickness sensor, which may knock it
out of adjustment. The sensor's approximate location is
shown in the figure above. You can also flex the back side
of the Top Cover slightly outward, toward the rear of the
printer, while removing the cover.
CP(W2) M4x6 screws
Paper Thickness Sensor
59