Lower Paper Guide Removal - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

LOWER PAPER GUIDE REMOVAL

After reinstalling the Lower Paper Guide, you must perform
the Cutter Position Adjustment.
Preparation: Remove the Maintenance Cover as described in
Cover Removal on page 58.
1. Remove the eight screws (CP(W2) M3x6) securing the Lower Paper
Guide.
CP(W2) M3x6
Figure 4-11. Lower Paper Guide Screws
Disassembly & Assembly
2. While supporting the Front Cover with your hands, lower the Lower Paper
Guide as shown below. You may find it helpful to move the Front Cover up
and down while removing the Lower Paper Guide.
Maintenance
When installing the Lower Paper Guide, push it all the way
up before tightening the screws; this is most likely the
correct position for the Guide in relation to the cutter blade.
However, you should also verify its position by performing
the Cutter Position Adjustment as described in Chapter 5.
Lower Paper Guide
Figure 4-12. Lower Paper Guide Removal
63