Rp24Xx Server Rs-232 System Local Console Installation; Console Configuration (Vt100 Mode); Figure 1-5. Console/Remote-Modem/Ups Connector - HP A4500A - VMEbus Single Board Computer 744 Motherboard Manual

HP rp2400 Series of Servers - Basic Cable Connections
Console Connection and Configuration

rp24xx Server RS-232 System Local Console Installation

The following describes how to install a system console on an rp24xx Server. The HP-700 series terminal is
used as an example. Other terminals may be used as a system console as long as they are configured for
VT100 terminal emulation mode.
1. Connect the 25-pin end of the A5191-63001 adapter cable to the 25-pin connector on the Console/UPS Port
located on the rear.
2. Connect the 9-pin, "Console," connector of a A5191-63001 adapter to the 9-pin D-type connector on a
24542G RS-232 cable.
Figure 1-5 Console/Remote-Modem/UPS Connector
100-240V~, 600W
6.0-2.6A, 50-60Hz
Ultra 2 W ide SCSI
Path: 0/0/1/ 0
ccrr012
3. Connect the 25-pin end of the 24542G serial cable to the serial/RS232 port on the Console. (RS232 Serial
Port labeling may vary depending on manufacturer.)
4. Connect the System Console to input AC power.
5. Turn the System Console AC power switch to ON.

Console Configuration (VT100 mode)

The following describes the steps required to configure system consoles for VT-100 mode for operation with
the rp24xx server.
C1099A VT-100 Mode Configuration.
The following procedure outlines the steps to configure the C1099A terminal for VT-100 operation.
To access the Setup menu in HPTerm emulation:
1. Press the key to display the terminal local function labels, then Press
F10
You are now in the Quick (
2. Select the VT100 emulation by using the space bar to navigate through the available options.
3. Press the key to save selected setup parameters and to exit the Setup menu.
ESC
4. Press the key when the blinking prompt
Y
Save all? (Y/N)
appears in the upper right corner of the menu to save the settings in non-volatile memory.
12
GSP Reset TO C
A
B
Narro w S ingle Ended SCSI 10/100BASE- T
Path: 0/0/2/ 0 Path: 0/0/0/ 0
Console/Remote-Modem/UPS Connector
(D-Type 25-Pin female)
Requires: A5191-63001 "W" adapter cable
) menu.
F1
10BASE- T Console/
LAN Consol e UPS Por t
wi n wi n
Path: 0/2/0 Path: 0/4/0
urbo urbo
Path: 0/6/2
Path: 0/6/ 0
(config keys).
F8
Chapter 1