Finalizing The Rack Mount Procedure; Sliding The Switch Into The Rack; Attaching L-Shaped Brackets To Rails - HP StorageWorks 2/64 - Core Switch Installation Manual

1 Two L-shaped brackets
2 Aligning top screw in hole #37
Figure 8

Attaching L-shaped brackets to rails

Finalizing the rack mount procedure

This section tells you how to slide the switch into the rack and secure the chassis to the
rack rails.

Sliding the switch into the rack

1. Before lifting the chassis into the rack, determine an easy access route for cables or cords.
Make sure that cables do not get pinned under the weight of the chassis.
2. Position the lift device next to the switch.
3. Position one technician at the front of the chassis, and the second technician at the rear of
the chassis. Carefully move the chassis onto the lift device.
40 Installing and configuring the switch
1
2
3 1/4-20 x 1/2 inch Phillips
panhead screws and
square washers
3
SHR-2512A