Installing Frus; Replacing The Chassis Door - HP StorageWorks 2/64 - Core Switch Installation Manual

4 Installing FRUs

The FRUs in the Core Switch 2/64 and the SAN Director 2/128 can all be removed and
replaced without special tools. Replacement instructions are provided with each replacement
unit ordered. The switch can continue operating during many of the FRU replacements if the
conditions specified in the procedure are followed.
This chapter provides the following topics:
• Replacing the chassis
• Replacing the cable management
• Replacing the cable guides
• Replacing a 16-port card and filler
• Replacing a CP
• Replacing a power supply and filler
• Replacing a blower
• Replacing the WWN bezel and

Replacing the chassis door

NOTE: The chassis door is required to ensure the Core Switch 2/64 and SAN
Director 2/128 meets EMI and other regulatory certifications.
1. Remove the chassis door from the switch:
a. Open the door to an angle of approximately 90 degrees.
b. Support the door to prevent it from falling. Push the spring-loaded pin on the upper
hinge up and into the notch in the hinge (see
pin on the lower hinge down and into the notch. Pull the door away from the chassis.
2. Install the new door in the chassis:
a. Verify that the levers on the spring-loaded pins on both hinges are pushed into the
notches.
b. Align the spring-loaded pins with the chassis portion of the hinges.
door, page 87
tray, page 88
(pillars), page 90
panel, page 90
card, page 97
panel, page 110
assembly, page 113
card, page 115
Core Switch 2/64 and SAN Director 2/128 installation guide
Figure 20), and push the spring-loaded
87