•
Logical IP addresses: A logical IP address and subnet mask for both logical switches
(modifiable through the ipAddrSet command).
•
Switch names for both logical switches (modifiable through the switchName command).
•
Switch status policies (modifiable through the switchStatusPloicySet command).
•
Core PID setting (modifiable through the configure command).
Table 5
lists Core Switch 2/64 default configuration settings.
Table 5
Core Switch 2/64 default parameters
Parameter
Switch Name for Logical Switch 0
Base IP Address for Logical Switch 0
Logical Switch 0 and 1 Subnet Mask
CP card 0 and 1 Subnet Mask
Ethernet Link Mode
CLI Timeout
SAN Director 2/128
The SAN Director 2/128 ships with the following factory-installed settings:
•
IP addresses (or native IP address), host names, subnet masks, and gateway addresses for
both CP cards
•
IP address and subnet mask for the SAN Director 2/128
•
Director name
•
Switch status policies
•
Domain ID for the SAN Director 2/128 (optional)
•
WWN for the SAN Director 2/128
NOTE:
The SAN Director 2/128 WWN is initially set by the factory to match the license ID
(which is based on the chassis serial number). The WWN can be changed, but the license ID
cannot be modified.
54
Installing and configuring the switch
Default
sw0
10.77.77.77
255.255.255.0
255.255.255.0
Auto
15 Minutes