Verifying Operation Of The New Cp Card - HP StorageWorks 2/64 - Core Switch Installation Manual

Verifying operation of the new CP card

1. Verify that boot and POST are complete on the new CP card (which takes a minimum of
3 minutes) and that the CP cards have achieved failover redundancy:
a. Wait until the Status LEDs on both CP cards are off.
NOTE: The Status LED on the active CP card displays yellow until the active CP card is fully
operational, and the Status LED on the standby CP card displays yellow until the CP cards have
achieved failover redundancy.
b. Enable the redundancy feature by entering the haEnable command from the serial
console for the active CP card.
c. From the serial console for the active CP card (which should still be the CP card that was
not replaced), enter the haShow command and verify that the command output
includes HA Enabled, Heartbeat Up, State Synchronized.
NOTE: If the command output does not include HA Enabled, Heartbeat Up, State
Synchronized, POST is not complete or the CP cards have not yet achieved redundancy.
Wait a minute or two and reenter the command to verify that redundancy has been achieved.
swDir:admin> hashow
Local CP (Slot 5, CP0): Active
Remote CP (Slot 6, CP1): Standby
HA Enabled, Heartbeat Up, State Synchronized
swDir:admin>
Core Switch 2/64 and SAN Director 2/128 installation guide 105