Table 18
Terminal emulator configuration settings
Parameter
Port speed (bits per second)
Data protocol
Compression
Flow control
Databits
Parity
Stop bits
Modulation
4.
Follow the instructions from the modem manufacturer to set up and verify modem operation.
Verifying the modem connection
This section provides information about how to verify that the modems are correctly connected.
NOTE:
This procedure requires either a telco system to dial in to the modems or a terminal
emulation program on a laptop or workstation that has an attached modem. Refer to
up a remote modem
a terminal emulation program.
To verify the modem connection:
1.
Check that both modem cables are firmly connected.
2.
Power on the modems, if they are not already on.
NOTE:
The modems must be powered on and operational before the Core Switch 2/64 or
SAN Director 2/128 is powered on, to allow the switch to detect the modems during boot.
Value
115200*
Standard EC
Enabled
Hardware
8
None
1
Standard
system" on page 126 for instructions on setting up a remote modem with
Core Switch 2/64 and SAN Director 2/128 installation guide
"Setting
127