Manage Cables - HP StorageWorks 2/64 - Core Switch Installation Manual

8. Modify passwords, if desired. Passwords can be 8 to 40 characters long and should
include a combination of numbers and upper/lowercase letters
password, press Ctrl-C.
Example:
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
Password was not changed. Will prompt again at next login
until password is changed.
swDir:admin>
9. Check the Active CP LED on the CP cards in slots 5 and 6 (see
haShow command to verify which CP card is active.
The configuration can be modified only through a login session to the active CP card.
Example:
swDir: admin> haShow
Local CP (Slot 6, CP1): Active
Remote CP (Slot 5, CP0): Standby
HA Enabled, Heartbeat Up, State Synchronized

Manage cables

The SAN Director 2/128 cables can be managed in a variety of ways, including the routing
them, as follows:
• Through the cable management tray
• Out either side of the chassis
• Through patch panels or cable channels on the sides of the rack
Core Switch 2/64 and SAN Director 2/128 installation guide
.
To skip modifying the
Figure 11), or enter the
47