Finalizing The Rack Mounting Procedure; Positioning The Switch In The Hp 9000 Series Rack - HP StorageWorks SAN Switch 2/32 Installation Manual

Installing the SAN Switch 2/32

Finalizing the Rack Mounting Procedure

Read this section to finalize the rack mount procedure.

Positioning the Switch in the HP 9000 Series Rack

Follow these steps to install the switch in the rack.
IMPORTANT: If installing more than one SAN Switch 2/32 directly on top of one another (in a
3U space) you must mount the slide rails attached to the switch using the set of holes on the top
of the switch, and the bottom using the set of holes on the bottom of the switch.
1. Depending on the type of install (front or rear access), slide the outer slide rails all
the way toward the front or back of the rack.
2. Carefully lift the switch into the rear of the rack, inserting the inner slide rails
(attached to the switch) into the outer slide rails (attached to the rack), see
Figure 2–5.
3. Slide the switch in the rack, see Figure 2–5.
2–14 SAN switch 2/32 version 4.0.x installation guide