Enable Software Licenses - HP StorageWorks 2/64 - Core Switch Installation Manual

2. Position one of the SFP transceivers so that the key is oriented correctly to the port. Insert the
transceiver into the port until it is firmly seated and the latching mechanism clicks.
Transceivers are keyed so that they can be inserted only with the correct orientation. If a
transceiver does not slide in easily, ensure that it is correctly oriented. For instructions that
are specific to the transceiver model, refer to the transceiver manufacturer's documentation.
3. Position a cable so that the key (the ridge on one side of the cable connector) is aligned
with the slot in the transceiver; then, insert the key into the transceiver until the latching
mechanism clicks.
Cables are keyed so that they can be inserted only with the correct orientation. If a cable
does not slide in easily, ensure that it is correctly oriented.
4. Repeat step 1 through step 3 for the remaining ports.
5. Organize the cables as required. For recommendations regarding cable management,
refer to "Manage
6. Check the Core Switch 2/64 or the SAN Director 2/128 for switch and port status by
entering the switchShow command at the prompt.
The switchShow command provides detailed information about the switch. For more
information about this command, refer to the HP StorageWorks command reference guide
for the Fabric OS version running on your switch.
7. Check the fabric for ISLs, switch names, or other status by entering the fabricShow
command at the prompt.
The fabricShow command provides general information about the fabric. For details
about this command, refer to the HP StorageWorks command reference guide for the
Fabric OS version running on your switch.
8. To establish additional system parameters, use the configure command. For details
about this command, refer to the HP StorageWorks command reference guide for the
Fabric OS version running on your switch.

Enable software licenses

See "Verifying optional software
currently enabled licenses and activating or obtaining additional licenses.
cables" on page 47.
licenses" on page 133 for information about determining
Core Switch 2/64 and SAN Director 2/128 installation guide 61