13: Maintenance; Firmware And Configurations - Lantronix SecureLinx SLC8 User Manual

13: Maintenance

This chapter describes the tasks that the system administrator performs by using the pages of the
Maintenance tab and additional commands on the command line interface. It contains the
following sections:

Firmware and Configurations


System Logs

Audit Log

Email Log

Diagnostics

Status/Reports

Events

Banners

LCD and Keypad

Note: The features and functionality described in this chapter specific to PC Card use
are supported on SLC -02 part numbers. The features and functionality specific to USB
port use are supported on SLC -03 part numbers.
Firmware and Configurations
The SLC Firmware & Configurations page allows the system administrator to:
Configure the FTP, SFTP, or TFTP server that will be used to provide firmware updates and

save/restore configurations. (TFTP is only used for firmware updates.)
Set up the location or method that will be used to save or restore configurations (default, FTP,

SFTP, NFS, CIFS, USB port, or PC Card). Update the version of the firmware running on the
SLC.
Save a snapshot of all settings on the SLC (save a configuration).

Restore the configuration, either to a previously saved configuration, or to the factory defaults.

For dual boot SLCs, view the firmware version on each boot bank, select the bank to boot

from, and copy the contents of one boot bank to the other.
To configure settings:
1. Click the Maintenance tab.
SecureLinx SLC User Guide
Figure 13-1 shows the page that displays.
170