Step 2: Remove Front Bezel; For A Pedestal Netserver - HP D5970A - NetServer - LCII Manual

Chapter 2
3. Turn off power to the HP NetServer.
4. Disconnect the AC power cord(s) and all external cables from the
NetServer.
WARNING
Before removing the cover, always disconnect the power
cord(s) and unplug telephone cables. Disconnect telephone
cables to avoid exposure to shock hazard from telephone
ringing voltages. Disconnect the power cord(s) to avoid
exposure to high energy levels that may cause burns when
parts are short-circuited by metal objects such as tools or
jewelry.
Note that the power switch does NOT turn off the standby
power. Disconnect the power cord(s) to turn off standby
power. If the backlight on the front panel LCD is still on,
standby power is still on.

Step 2: Remove Front Bezel

To remove the front bezel, follow the procedure for your NetServer configuration:
HP NetServer in pedestal configuration
HP NetServer in an HP rack
HP NetServer in a Compaq rack

For a Pedestal NetServer

For an HP NetServer in pedestal configuration, do the following to remove the
front bezel:
1. If the NetServer is on casters, lock them to prevent movement of the
NetServer.
2. Unlock the front bezel lock with the key, if necessary.
3. The front bezel snaps into the face of the NetServer chassis with connectors
at the top front of the chassis, and it fits into slots on the bottom front of the
chassis. Pull the bezel forward until it unsnaps from these connectors, then
lift the bezel forward and upward from the chassis face, as shown in
Figure 2-1.
8
Installation