Step 10: Install Hard Disk Drive Modules - HP D5970A - NetServer - LCII Manual

Chapter 2
6. Push the front bezel onto the NetServer, as shown in Figure 2-29.
Figure 2-29. Push Front Bezel into Place on Compaq Rack
7. If you removed the door of the rack, replace it.

Step 10: Install Hard Disk Drive Modules

If the secondary hot-swap mass storage cage is locked, unlock it with its key.
Refer to the HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User
Guide, and install the disk drive modules into the secondary hot-swap mass
storage cage. Install all required disk spacers and filler panels.
Remove filler panels from the secondary hot-swap mass storage cage at the
positions where you plan to install disk drive modules.
Filler panels must occupy in all empty disk drive locations in the hot-swap
mass storage cage.
38
Installation