Step 6: Install Scsi Cable - HP D5970A - NetServer - LCII Manual

Chapter 2
2. Remove Fan Assemblies 0 and 1, as follows:
a. Press firmly on the catch in the top of one fan assembly, shown in
Figure 2-14, and swing the upper side of the fan assembly away from
the accessory board guide.
b. Pull the fan assembly gently upward to disengage its prongs on the far
side of the fan assembly. Remove the fan assembly from the NetServer.
c. Repeat actions a. and b. for the other fan assembly.

Step 6: Install SCSI Cable

Install the SCSI cable supplied with the kit, as follows:
1. Gently pull aside the cables for the flexible disk drive and CD-ROM drive
to gain access to the SCSI B connector on the I/O board, which is shown in
Figure 2-15.
Figure 2-15. Connect SCSI Cable to I/O Board's SCSI B Connector
2. Connect the SCSI cable's 68-pin connector labeled "To I/O Board" to the
SCSI B connector on the I/O board, as shown in Figure 2-15.
24
Installation
SCSI B SE Connector
(For Non-Hot-Swap Drives Only)
SCSI B
Connector
SCSI Cable
Connector Labeled
"To I/O Board"
I/O Board