For A Netserver In A Rack - HP D5970A - NetServer - LCII Manual

Chapter 2

For a NetServer in a Rack

Do the following to remove the fan assemblies from an HP NetServer in a rack:
1. Disconnect the fan cables from the Fan 0 and Fan 1 connectors on the
system backplane. These connectors are shown in Figure 2-13 for the
HP NetServer LH 3.
Fan 0 Assembly
Figure 2-14. Remove Fan Assemblies from NetServer in Rack Configuration
(Shown for HP NetServer LH 3r; Details of Fan Cables May Vary)
Fan 1 Assembly
Fan 1 Cables Catch
Catch
Installation
23