Tools You Need; Documents You May Need - HP D5970A - NetServer - LCII Manual

Chapter 1
CAUTION An insulating sheet covers the cage's management board and
backplane. Leave it in place, and be careful not to damage it.

Tools You Need

The following materials are also required to install this upgrade:
Antistatic Service Kit (3M
containing a wrist strap, antistatic mat, and cable. Use this kit to prevent
damage to the system from static electricity.
T-15 Torx driver
T-25 Torx driver
HP NetServer Navigator CD-ROM (required for RAID configuration)

Documents You May Need

Refer to the following documents supplied with your NetServer:
User guide: the HP NetServer LH 3/LH 3r User Guide or the HP
NetServer LH 4/LH 4r User Guide
Road map: the HP NetServer LH 3 Installation Road Map, the HP
NetServer LH 3r Installation Road Map, the HP NetServer LH 4
Installation Road Map, or the HP NetServer LH 4r Installation Road Map
Integrated HP NetRAID Controller Configuration Guide
The HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide
is supplied with accessory Ultra2 SCSI hot-swap hard disk drives and trays.
If you have a NetServer installed in a rack, refer to either the Rack Cabling
Reference for the HP NetServer LH 3r, or to the HP NetServer LH 4r Rack
Cabling Reference, and to the appropriate reference listed below:
For an HP Systems rack: Appendix A of the HP NetServer LH 3/LH 3r
User Guide or the HP NetServer LH 4/LH 4r User Guide
For an HP Rack System/E rack or HP Rack System/U rack: Chapter 8
of the HP NetServer LH34/LH 3r User Guide or the HP NetServer
LH 4/LH 4r User Guide
For a Compaq rack: HP NetServer LH 3r Installation Guide for
®
Compaq 4000/7000 Racks or HP NetServer LH 4r Installation Guide for
®
Compaq 4000/7000 Racks
The HP NetServer Online Documentation CD-ROM contains all of the documents
listed above.
6
®
part number 8501/8502/8505 or equivalent)
Introduction