HP D5970A - NetServer - LCII Manual page 24

Chapter 2
CAUTION As you insert the cage, be careful not to damage the cage's
backplane, management board, and the insulating sheet
covering them (not shown in Figure 2-11).
2. Insert the hot-swap mass storage cage by sliding it carefully into the mass
storage expansion bay, as shown in Figure 2-11.
3. When the cage is correctly positioned, press it firmly into place, so that its
flanges are flush with the NetServer chassis front.
4. Using the two circular access holes in the NetServer chassis shown in
Figure 2-12, insert and tighten two screws supplied with the upgrade kit.
HP NetServer LH 3 or LH 4 access holes are on the side of the chassis.
HP NetServer LH 3r or LH 4r access holes are on the top of the chassis.
1
Access Holes
Pedestal Configuration
Figure 2-12. Insert and Tighten Two Screws (1), and Then Insert and Tighten
Six Screws (2); Shown for HP NetServer LH 3 and LH 3r
20
1
Access Holes
2
Rack-Optimized Configuration
Installation
2