Fcarray Assistant Software Installation; Software Preparation; Check The Latest Versions - HP D5970A - NetServer - LCII Installation And User Manual

2 FCArray Assistant Software
Installation

Software Preparation

The HP NetServer Navigator CD-ROM is run on the HP NetServer to create the
diskette(s) used to install the FCArray Assistant software. After the diskettes are
created, the HP NetServer Navigator CD-ROM is no longer needed. The
diskette(s) are then used to install the FCArray Assistant software from within
Windows NT 4.0, on both the managed server and the remote management
workstation.
If this is the initial installation of the FCArray Assistant software, continue
to the following section, "Check the Latest Versions."
If the FCArray Assistant installation diskette(s) have already been created,
proceed to the section "Software Installation."
NOTE The software installation procedures require administrator
rights for both the server and the client.
CAUTION
Files for the FCArray Assistant software are decompressed
during the installation procedure and then copied to the target
drive. Simply copying the files to a hard disk will NOT result
in a successful installation.
NOTE
The FCArray Assistant Server software component is only
required on a managed server and not on a remote management
workstation. However, the FCArray Assistant Client software
should be installed on both a managed server and a remote
management workstation.

Check the Latest Versions

To ensure you have the latest version of the software, obtain the current Status
Report for your HP NetServer Navigator CD-ROM. This report describes any
7