Software Installation Procedure; Preparing A Pc Running Windows Nt 4.0 (Hp Desktop Pcs) - HP Brio BA200 User Manual

Software Installation Procedure

Make sure you have carried out the tasks outlined in "Before Installing
the Software" on page 22 before proceeding with the following:
1 Prepare your PC (PCs running Windows NT 4.0 only).
2 Install the drivers, software and smart card reader.
3 Install other items, if required (TopTools hardware resource
monitoring utility and this manual).

Preparing a PC Running Windows NT 4.0 (HP Desktop PCs)

Windows NT 4.0
1 Install Microsoft Windows NT 4.0 Service Pack 6a from the
ProtectTools 2000 CD-ROM (if you do not already have Service Pack
4 or later installed) and restart the PC.
To find Service Pack 6a, go to the
open the folder for your language. To install, double-click on the
setup program
2 If you are currently using HP NTLock on your PC (and it is older than
version 2.2) or you want to use it:
a Uninstall the version of HP NTLock currently on the PC using the
Add/Remove Programs
Panel
b Restart the PC.
c Install the appropriate version of HP NTLock provided (or any
later version). Two versions are supplied, one for HP Vectra VL
and VLi PCs only (not for Vectra VE and VEi PCs) and the other
(the light version without power management) for HP Kayak PC
Workstations. The Vectra version is in the folder
ntlock\vectra\disk1
ntlock\kayak\disk1.
sp6i386.exe
utility in
).
and the Kayak version in
2 Installing HP ProtectTools 2000 Software
Software Installation Procedure
Microsoft\sp6ai386
.
Ö
Start Settings
folder, then
Ö
Control
23