Checking The Program Setting And Setting Attribute - Brother BAS-761 Instruction Manual

Checking the program setting and
setting attribute

Checking the program setting and setting attribute

The following items are displayed.
The cylinder operates when chancing option output, two row switch, and two step tension
setting.
The option output is connected to the following ports
Two row switch can be set only in one position in one program. The newly set point be-
comes valid if two row switch is already set in the program.
Attribute of items marked with * are available for setting.
An example of stitch data is shown below.
Stitch length
Current stitch count
Total stitch count
Current coordinate
Distance from the previous position in the X and Y axial directions
Stitch length
End code
Current needle position / Total stitch count
Stitch data type
Needle tacking (*)
Two step tension setting (*)
Two row switch (*)
Option output (*)
Slow conversion (*)
Feed data type
Option output (*)
Number of connector
Number of common pin
Number of signal pin
Stitch data type
Needle tacking (*)
Programmer
Chapter 3 Programming with Command Function
is displayed.
Needle tacking is set for each stitch.
Two step tension output is set in the current needle position.
The clamp is set inside when it is set to ON and is set
outside when it is changed from ON to OFF.
Whether option output is conducted or not is set.
Three successive stitches at low speed are set. Values 500
to 33500 rpm are available for the speed.
is displayed.
Whether option output is conducted or not is set.
P26(MN-OPT-OUT)
5 or 6 (+24V)
1
Current stitch count
Distance from the previous point in
the direction of X or Y axis
End code
Slow conversion (*)
Two row switch (*)
Option output (*)
Two step tension setting (*)
111