Brother BAS-761 Instruction Manual page 147

Chapter 5 Practical programming examples
11. Repeat step 10 and create the program to point
G.
12. When point G is programmed, press
Point G is programmed to be a corner. To change the stitch length,
press to set it again.
ESC ESC
13. Create the program to point L.
14. When point L is programmed, press
15. Press twice.
ESC ESC
16. Select with
17. Press .
18. Move the needle with
the needle point is at point M of the pattern.
19. When point M is programmed, press
20. Select with
21. Input the number of stitches to return the needle
to the position where two row switch is input,
then press
5 is input in the example. The needle moves 5 stitches back.
22. Press .
The attribute setting screen appears.
146
, then press
. Press
, then press
.
again.
again.
.
when
twice.
ESC ESC
.
Programmer