Editing Data; Changing Stitch Length Of The Program - Brother BAS-761 Instruction Manual

Chapter 3 Programming with Command Function

Editing data

Command to be used
This function is available only when the needle is at the standby position.
The pitch of the needle tacking data is not changed. The following settings of attributes
become invalid when changing the pitch. Set them again after changing the pitch.
1.
2.
3.
116

Changing stitch length of the program

Changing the stitch length of the program
M
1 1 1
* Two step tension setting
* Two row switch
* Option output
* Slow conversion
Check to see that the needle at in the standby position.
Press if it is not at the standby position.
R
Input
1 1 1 M
Displays the number of the command input.
Input the stitch length in 3 digits, then press
Stitch length
.
Programmer
.
L