Information Checklist; Enable 802.1X; Enable 802.1X Using The Centreware Internet Service - Xerox 3635MFP - Phaser B/W Laser System Administration Manual

The Administrator can configure the machine to use one EAP type. EAP types supported on
the Xerox machine are:
• EAP-MD5
• PEAPv0/EAP-MS-CHAPv2
• EAP-MS-CHAPv2

Information Checklist

1. 802.1X authentication must be supported on the network where Xerox machines are
connected.
2. Ensure that your 802.1X Authentication Server and authentication switch are
available on the network.
3. Create a Username and Password on your Authentication Server which will be used
to authenticate the machine.
NOTE:

Enable 802.1X

1. Press the <Log In/Out> button on the machine to enter the Tools Pathway.
2. Enter the Administrator's Password. The default is 1111.
3. Touch [Enter].
4. Press the <Machine Status> button.
5. Touch the [Tools] tab.
6. Touch [Connectivity & Network Setup].
7. Touch [Advanced].
8. Touch [Network Setting]
9. Touch [802.1X].
10. Touch [Enable].
11. Touch the EAP type used on your network.
12. Touch the keyboard button.
13. Enter the Username required by your authentication server.
Touch [Enter].
14.
15. Enter the Password required by your authentication server.
16. Touch [Enter].
17. Touch [Save].

Enable 802.1X using the CentreWare Internet Service

1. At your Workstation, open the web browser, enter the TCP/IP Address of the machine
into the Address bar.
Xerox Phaser 3635 System Administration Guide
Write down the Username and Password and keep in a safe place.
802.1X Authentication
137