Procedure - Xerox 3635MFP - Phaser B/W Laser System Administration Manual

3 Network Installation

Procedure

Installation via DHCP (Dynamic Host Configuration Protocol)
DHCP is enabled on the machine by default. If the machine is connected to the network, the
TCP/IP information will be configured when the machine is powered on and no further
configuration is required.
1. Print a Configuration Report to verify that the information was assigned correctly.
Installation via BOOTP or DHCP
Ensure your machine is connected to the network with Ethernet cabling.
1. Press the <Log In/Out> button on the machine to enter the Tools Pathway.
2. Enter the Administrator's Password. The default is 1111.
3. Touch [Enter].
4. Press the <Machine Status> button.
5. Touch the [Tools] tab.
Touch [Connectivity and Network Setup].
6.
7. Touch [Advanced].
8. Touch [Network Setting].
9. Touch [Network Setup].
10. Touch [TCP/IP Options].
11. Touch [TCP/IP Settings].
12. Touch [Dynamic Addressing]. By default, DHCP is selected.
13. Select the required Dynamic Addressing method:
•
•
14. Touch [Save].
15. Touch [Close].
16. Touch [TCP/IP - Line Printer].
17. Touch [Enable].
If you wish to change the LPR port for your printer, touch [Port Number] and enter
18.
the desired port number at the keypad.
NOTE:
print jobs, it is recommended that you do this ONLY with extreme caution as most
LPR spoolers are set to send print jobs to the default port, 515.
Touch [Save].
19.
Touch [HTTP].
20.
21. Touch [Enable].
22. Touch [Save].
16
[BOOTP].
[DHCP].
While you can change the port number at which your machine will accept LPR
Xerox Phaser 3635 System Administration Guide