Procedure - Xerox 3635MFP - Phaser B/W Laser System Administration Manual

1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
6. Host Name for the machine.

Procedure

1. Follow the steps in Chapter 3, Configure Static IPv4 Addressing using the Machine
User Interface, Procedure on page 14 until step 38, then return to this page.
Configure the Client
1. Add the machine printer Host Name to the etc/hosts file.
2. Ensure that you can ping the machine.
3. Use either the GUI method or the tty method as detailed below:
GUI Method
1. Open a command window from the Desktop.
2. Enter su to access Super User mode.
3. Enter admintool to run the System Administrator Tool.
4. Click on [Browse:Printers].
5. Click on [Edit:Add:Access to Printer...].
6. Enter the following information into the [Access to Remote Printer] form:
a) Printer Name: queuename.
b) Print Server: hostname.
c) Click on [OK] to complete the form.
7. Enter sh to run the Bourne shell.
8. Enter the command: lpadmin -p queuename -s hostname !lp to modify the remote
queuename.
9. Enter Exit to exit the Bourne shell.
10. Enter Exit to exit Super User mode.
11. Test the queue created, by entering the command:
lp -d queuename /etc/hosts.
12. Verify that the job prints at the machine.
Xerox Phaser 3635 System Administration Guide
Where queuename is the name of the queue being created.
Where hostname is the machine hostname from the /etc/hosts file.
Unix
25