Resetting The Snmp Configuration - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

The following example configures SNMP trap 1:
8/20q FC Switch (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
Do you want to save and activate this snmp setup? (y/n): [n]

Resetting the SNMP configuration

To reset the SNMP configuration back to the factory defaults, enter the reset snmp command in an
Admin session, as shown in the following example. See
factory defaults.
8/20q FC Switch (admin) #> reset snmp
124 Simple Network Management Protocol configuration
True
10.20.33.181
5001
info
2
northdakota
(True / False)
(hostname, IPv4, or IPv6 Address) :
(decimal value, 1-65535)
(select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark
(1 / 2)
(string, max=32 chars)
:
:
:
:
:
Table 22 for a listing of the SNMP configuration