Configuring A Radius Server On The Switch - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Fibre channel switch
Hide thumbs Also See for AK241A - StorageWorks 8Gb Simple SAN Connection:
Table of Contents

Advertisement

Configuring a RADIUS server on the switch

To configure a RADIUS server on the switch, enter the set setup radius command. There are two
groups of RADIUS configuration parameters. One group of parameters is common to all RADIUS server
configurations. The second group is server-specific. You can configure both groups of parameters for all
RADIUS servers, or you can configure the common and server-specific parameters separately. See
Table 48
and
parameters.
The following example configures the common RADIUS server configuration parameters:
8/20q FC Switch (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder
UserAuthOrder
TotalServers
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder
UserAuthOrder
TotalServers
Do you want to save and activate this radius setup? (y/n): [n]
100 RADIUS server configuration
Table 49
for descriptions of the common and server-specific RADIUS configuration
Local
Local
1
1=Local, 2=Radius, 3=RadiusLocal :
1=Local, 2=Radius, 3=RadiusLocal :
decimal value, 0-5
:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks sn6000 - fibre channel switch8/20q

Table of Contents