HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 47

To configure the switch services, enter the set setup services command in an Admin session, as
shown in the following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PLEASE NOTE:
-----------
* Further configuration may be required after enabling a service.
* If services are disabled, the connection to the switch may be lost.
* When enabling SSL, please verify that the date/time settings
on this switch and the workstation from where the SSL connection
will be started match, and then a new certificate may need to be
created to ensure a secure connection to this switch.
TelnetEnabled
SSHEnabled
GUIMgmtEnabled
SSLEnabled
EmbeddedGUIEnabled
SNMPEnabled
NTPEnabled
CIMEnabled
FTPEnabled
MgmtServerEnabled
CallHomeEnabled
Do you want to save and activate this services setup? (y/n): [n]
(True / False) [True ]
(True / False) [False]
(True / False) [True ]
(True / False) [False]
(True / False) [True ]
(True / False) [True ]
(True / False) [False]
(True / False) [False]
(True / False) [True ]
(True / False) [True ]
(True / False) [True ]
8/20q Fibre Channel Switch command line interface guide 47