HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 182

switch
Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic
and does the following:
• Activates the pending firmware
• Closes all management sessions
• Clears the event log. To save the event log before resetting, see the
To reset the switch with a power-on self test, see the "hardreset" on page 155. To reset the switch
without disrupting traffic, see the "hotreset" on page 158.
NOTE:
• Firmware image files that have not been unpacked
• Configuration backup files
• Support files
system
Resets the following system configuration settings to the factory default values:
• DNS host
• IPv4 Ethernet
• IPv6 Ethernet
• Event logging
• NTP
• Timers
NOTE:
communication with the switch. This operand does not affect installed license keys.
zoning
Clears the zoning database and deactivates the active zone set. The zoning configuration
parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See
Table 21
182 Command reference
The following files are deleted from the switch during a switch reset:
(Table 25)
(Table 26)
(Table 27)
(Table 28)
(Table 29)
(Table 30)
Because this operand changes network parameters, the workstation could lose
for information about the zoning configuration parameters.
"set log" on page 206.