Set Port; Transmission Speed Parameters; Port Administrative State Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

set port

Description Sets port state and speed for the specified port temporarily until the next switch reset or new
configuration activation. This command also clears port counters.
Authority Admin session
Syntax
set port clear
or
set port [port_number]
clear
speed [transmission_speed]
state [state]
Operands
[port_number]
Specifies the port. Ports are numbered beginning with 0.
clear
Clears the counters on all ports or the port given by [port_number].
speed [transmission_speed]
Specifies the port transmission speed.
Table 45
Parameter
2Gb/s
4Gb/s
8Gb/s
Auto
state [state]
Specifies the port administrative state.
parameters.
Table 46
Parameter
Online
Offline
Diagnostics
Down
See also show port, page 256
210 Command reference

Transmission speed parameters

Description
The port speed is 2 Gb/s.
The port speed is 4 Gb/s.
The port speed is 8 Gb/s.
The port speed is automatically detected.

Port administrative state parameters

Description
Activates and prepares the port to send data
Prevents the port from receiving signal and accepting a device login
Prepares the port for testing and prevents the port from accepting a device
login
Disables the port by removing power from the port lasers
Table 45 describes the transmission speed parameters.
Table 46 describes the port administrative state