HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 257

Fibre channel switch
Hide thumbs Also See for AK241A - StorageWorks 8Gb Simple SAN Connection:
Table of Contents

Advertisement

Table 64
Show port display entries (continued)
Parameter
Flowerrors
FReject
InvalidCRC
InvalidDestAddr
IOStreamGuard
LinkFailures
LinkSpeed
LinkState
LIP_AL_PD_ALPS
LIP_F7_AL_PS
LIP_F8_AL_PS
LIP_F7_F7
LIP_F8_F7
Login
LoginStatus
Logout
LongFramesIn
LoopTimeouts
LossOfSync
LostFrames
LostRRDYs
MaxCredit
MediaSpeeds
MediaPartNumber
MediaRevision
Description
Number of frames received there were no available credits
Number of frames from devices that were rejected
Invalid CRC detected
Invalid destination address detected
I/O StreamGuard status
Number of optical link failures detected by this port. A link failure is a
loss of synchronization or a loss of signal while online. A loss of signal
causes the switch to attempt to re-establish the link. If the link is not
re-established, a link failure is counted. A link reset is performed after a
link failure.
Port transmission speed
Port activity status
Number of F7, Arbitrated Loop Source Address (AL_PS) Loop
Initialization Primitives (LIPs), or Arbitrated Loop Destination Address
(AL_PD) (vendor specific) resets performed
Number of LIP frames that reinitialized the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is trying to
restore the loop.
Number of LIP frames indicating a loop failure detected by the L_Port
identified by AL_PS
Number of LIP frames that acquire a valid Arbitrated Loop Physical
Address (AL_PA)
Number of LIP frames indicating that a loop failure has been detected
at the receiver
Number of device logins that have occurred on the port
Device login status for the port: LoggedIn or NotLoggedIn
Number of device logouts that have occurred on the port
Number of incidents when one or more frames that are greater than the
maximum size were received
A two second timeout, as specified by FC-AL-2
Number of synchronization losses (>100 ms) detected by this port. A
loss of synchronization is detected by the receipt of an invalid
transmission word.
Number of incidents of lost frames
Number of incidents of lost Receiver_Ready (R_RDY) primitives
Maximum number of port buffer credits
Possible transmission speeds for the port
Transceiver vendor part number
Transceiver revision number
8/20q Fibre Channel Switch command line interface guide 257

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks sn6000 - fibre channel switch8/20q

Table of Contents