To enable and configure port threshold monitoring on the switch, enter the set config threshold
command:
8/20q FC Switch #> admin start
8/20q FC Switch
8/20q FC Switch (admin-config) #> set config threshold
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
ThresholdMonitoringEnabled
CRCErrorsMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
DecodeErrorsMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
ISLMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LoginMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LogoutMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LOSMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
Finished configuring attributes.
This configuration must be saved (see config save command) and activated (see
config activate command) before it can take effect.
To discard this configuration use the config cancel command.
8/20q FC Switch (admin-config) #> config save
8/20q FC Switch (admin-config) #> config activate
68
Port configuration
(admin) #> config edit
(True / False)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
[False
]
[True
]
[25
]
[1
]
]
[True
]
[25
]
[0
]
]
[True
]
[2
]
[0
]
]
[True
]
[5
]
[1
]
]
[True
]
[5
]
[1
]
]
[True
]
[100
]
[5
]
]