HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 221

The following is an example of the set setup snmp trap command:
8/20q FC Switch (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
Do you want to save and activate this snmp setup? (y/n): [n]
See also show setup snmp, page 265
True
10.20.33.181
5001
info
2
northdakota
(True / False)
(hostname, IPv4, or IPv6 Address) :
(decimal value, 1-65535)
(select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark
(1 / 2)
(string, max=32 chars)
8/20q Fibre Channel Switch command line interface guide 221
:
:
:
:
: