Firmware Install - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

firmware install

Description Downloads firmware from a remote host to the switch, installs the firmware, then resets the switch to
activate the firmware. This is disruptive. The command prompts you for the following:
• The file transfer protocol (FTP or TFTP)
• IP address or DNS host name of the remote host
• An account name and password on the remote host (FTP only)
• Pathname for the firmware image file
Authority Admin session
Syntax
firmware install
Examples The following is an example of the firmware install command using FTP:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> firmware install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
FTP or TFTP
User Account
IP Address
Source Filename : 7.6.00.xx_epc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
Press 'q' and the ENTER key to abort this command.
: ftp
: johndoe
: 10.0.0.254
This process will cause a disruption
Do you want to continue? [y/n] y
8/20q Fibre Channel Switch command line interface guide 147