Table of Contents
Advertisement
9 Click Start to run the External Loopback Test.
The test runs ten times by default. If you want to change the
number of test repetitions, click Test Setup.
10 If the test fails, go to the section "What to Do If a Test Fails"
later in this chapter.
11 Remove the loopback plug and insert the network cable.
Viewing Test Results
The Test Results screen shown in Figure 6-6 appears after the
tests have been run, showing the number of times each test
was run and the pass/fail results.
Figure 6-6 Test Results Screen
Viewing Test Results
6-9
Advertisement
Table of Contents
