3Com ATMLINK 155 PCI User Manual page 74

Table 4-2 NetWare Keywords (cont'd)
Keyword (Default in Bold)
lec_config_mode 1, 2
(LEC configuration mode)
lecs_np
Default is 13-byte
(LECS network prefix) network portion of
ATM Forum
Well-known Address.
lecs_up 00a03e00000100
(LECS user part) is default
les _np 26-character ASCII
(LES network prefix) string
(13 hex digits)
les_up 14-character
(LES user part) ASCII string
(7 hex digits)
maxvcc 1–1024
(maximum number of
virtual channel circuits)
vpivci 0, 1, 2, 3
(VPI/VCI range)
ilmi_vpi
Depends on ATM
(VPI for ILMI) switch settings
ilmi_vci Depends on ATM
(VCI for ILMI) switch settings
rate 1–155
sig_version 0, 1
(signaling version)
Editing the AUTOEXEC.NCF File
Range of Values
Usage Rules
1=Automatic (uses ILMI or
user-supplied LECS address)
2=Manual (must supply address for
LES or LECS when using this option)
Use the 13-byte network prefix of the
switch on which the target LECS
resides.
Use the 7-byte user part of the 20-byte
ATM address of the target LECS.
Use the 13-byte network prefix of the
switch on which the target LES
resides.
Use the 7-byte user part of the
20-byte ATM address of the target
LES.
The default value is 1,024 VCCs. With
four NICs, the maximum number of
open VCCs is 4,096.
0=0/12 bits (default)
1=1/11 bits
2=2/10 bits
3=8/4 bits
Be sure that the VPI/VCI range is the
same for all installed NICs in the
system.
The default value is 0.
The default value is 16.
Sets the maximum bandwidth in Mbps
available to an LEC.
0=UNI v3.0
1=UNI v3.1 (default)
Make sure that all installed NICs in the
system use the same signaling
version.
4-25