Sc Duplex And Rj-45 Connectors - 3Com ATMLINK 155 PCI User Manual

2-4 C 2: H
HAPTER ARDWARE
13 Connect the power cables and turn on the power to the
computer.
14 Connect the 3C975 ATMLink NIC to the network.
The 3C975-F NIC uses 62.5/125 m multimode fiber-optic
cable with SC duplex connectors. The 3C975-UTP NIC uses
Category 5 unshielded twisted-pair cable with an RJ-45
connector. Both models are shown in Figure 2-3.
The physical installation of the ATMLink NIC is now complete.
Figure 2-3 SC Duplex and RJ-45 Connectors
It is strongly recommended that you run the ATMLink
diagnostic utility before attempting to install the network
drivers. The diagnostic utility verifies that the on-board
components of each NIC function correctly. This utility also
correlates the MAC address of the NIC with its PCI slot number.
You must know the PCI slot number to load, configure, or
reconfigure the Microsoft Windows NT network drivers.
The next step is to install the network software driver. For
server driver installation procedures, refer to Chapter 3 for
Windows NT, or to Chapter 4 for Novell NetWare.
I
NSTALLATION
A T M
SC connector
port
LED
L I N K
A T M
RJ-45
port
LED
L I N K