3Com ATMLINK 155 PCI User Manual page 61

4-12 C 4: N W
HAPTER ET
Table 4-1 3C975 ATMLink NIC NetWare Install Utility Configuration Parameters (cont'd)
Range of Values
Parameter (Defaults in Bold)
Maximum Frame Size 1514
4542
9232
Rate 1–155
LEC Configuration Automatic
Mode Manual
LECS Network Prefix ATM Forum
Well-known Address
(not shown)
00A03E00000100
LECS User Part
(not shown)
LES Network Prefix No default
LES User Part No default
Maximum VCCs 5–1024
Allowed
VPI/VCI Range 0 bits/12 bits
1 bits/11 bits
2 bits/10 bits
8 bits/4 bits
ILMI VPI 0
ILMI VCI 16
Signaling Version UNI v3.0
UNI v3.1
S D I
ARE ERVER RIVER NSTALLATION
Description
All ELANs with the same card number
must have the same MFS value, also
called maximum transfer unit (MTU). Use
1514 for Ethernet, 4542 for 4 Mbps
token ring, and 9232 for 16 Mbps token
ring. Only end stations using the same
value can interoperate.
Sets the maximum bandwidth in Mbps
available to an LEC.
Select Automatic for ILMI service. Select
Manual to connect with a specific LECS
or LES.
Enter the 13-byte network prefix of the
switch on which the target LECS resides.
Enter the 7-byte user part of the target
LECS address (the ESI plus 00 as the
selector byte).
Enter the 13-byte network prefix of the
switch on which the target LES resides.
Enter the 7-byte user part of the target
LES address (the ESI plus 00 as the
selector byte).
There are 4,096 open VCCs supported
per system (4 NICs per system).
This parameter is determined by the ATM
switch setting and must be the same for
all NICs in the system.
This parameter is determined by the ATM
switch setting.
This parameter is determined by the ATM
switch setting.
This parameter is determined by the ATM
switch setting and must be the same for
all NICs in the system.