3Com ATMLINK 155 PCI User Manual page 66

Configuring LECs and Resilient Server Links
14 Enter the LES user part if you selected Manual for the LEC
Configuration Mode.
This is the 7-byte hexadecimal (14-character) user part of the
target LES address. Enter the address without delimiters.
For example:
0E4A2C27456200
15 Select the VPI/VCI range.
The default value is 0 bits VPI, 12 bits VCI. This value is
determined by the ATM switch settings and must be the
same for all end stations on the network.
16 Select the ILMI VPI.
The default value is 0. This value is determined by the ATM
switch settings.
17 Select the ILMI VCI.
The default value is 16. This value is determined by the ATM
switch settings.
18 Select the signaling version.
UNI 3.1 is the default value. Select the version of UNI
supported by your switch.
19 When you have set all the configuration values, press [F10]
or [Esc] to move to the Driver Actions box.
20 Select Save parameters and load driver.
The install utility writes the appropriate load and bind
commands to the AUTOEXEC.NCF file and loads the LEC.
If no errors are encountered, the dialog box shown in
Figure 4-10 appears.
4-17