C975 Atmlink Nic Installation Configuration Parameters - 3Com ATMLINK 155 PCI User Manual

Table 3-1 describes the fields and buttons in the ATMLink
Installation and ELAN Configuration windows. Default values
are shown in bold.
Table 3-1 3C975 ATMLink NIC Installation Configuration Parameters
Range of Values
Field (Defaults in Bold)
ATMLink NIC All ATMLink NICs with
installed drivers by PCI
slot, bus number, and
MAC address (after
initial installation)
Global NIC Parameters (must be the same for all NICs in a computer system)
VPI/VCI Range 0 bits/12 bits
1 bits/11 bits
2 bits/10 bits
8 bits/4 bits
Signaling UNI v3.0
UNI v3.1
Local NIC Parameters (specific to each NIC in a computer system)
LAN Type Ethernet (802.3)
Token Ring (802.5)
ILMI VPI 0
ILMI VCI 16
Maximum Frame Size 1514
4542
9232
Resilient Server Link Any active NIC
(continued)
Installing the Network Driver
Description
Select the NIC you wish to configure
from the drop-down list.
This parameter is determined by the
ATM switch setting.
This parameter is determined by the
ATM switch setting.
All ELANs configured on a NIC must be
the same LAN type.
This parameter is determined by the
ATM switch setting.
This parameter is determined by the
ATM switch setting.
All ELANs on the same NIC have the
same MFS value, also called maximum
transfer unit (MTU). Use 1514 for
Ethernet, 4542 for 4 Mbps token ring,
and 9232 for 16 Mbps token ring.
Only end stations using the same value
can interoperate.
Select one or more eligible active NICs
to make the current ATMLink NIC a
standby NIC.
3-13