Self-Diagnostic Function; Messages During Normal Operation - Sharp MX-M202D Operation Manual

Message
(alarm sounds)
Toner is low.
Add toner.
Can not copy or print.
[OK]:RETURN
Unfold original and
return XX
original(s) to the
document feeder.
[START]:CONTINUE

SELF-DIAGNOSTIC FUNCTION

The machine has a self-diagnostic function that automatically stops operation if a problem occurs in the machine. If
a problem occurs in fax mode, the following display appears.
Message display
Call for service.
code:xx xx.
Main code Sub code

MESSAGES DURING NORMAL OPERATION

Message
SENT xx%
No.001 P-xxx
READING xx%
No.001 P-xxx
Stand-by. 100%
22 AUG FRI 10:25
ENTER DIAL #
Meaning of message
Toner is low.
There is no toner.
The detected original size
is smaller than the actual
original size, or a smaller
size has been selected.
Turn off the power and then turn it back on. If the error is not cleared, note the 2-digit
main code and the 2-digit sub-code and then contact your dealer.
This appears when a direct transmission ends ("xx" indicates the number of pages).
The original is being scanned into memory (during memory transmission).
The machine is in the standby state.
This appears when the [SPEAKER] key has been pressed.
Solution
Replace the toner
cartridge.
Replace the toner
cartridge.
Place the originals again
and make sure that the
size indicated in the
display is the same as the
actual original size.
Action
Meaning of message
TROUBLESHOOTING
Page
"REPLACING THE
TONER CARTRIDGE" in
the Operation Guide for
the machine
"REPLACING THE
TONER CARTRIDGE" in
the Operation Guide for
the machine
–
93
7