Using F-Code Polling Memory - Sharp MX-M202D Operation Manual

USING F-CODE POLLING MEMORY

In order for another machine to retrieve a document from your machine, you must first scan the document into the
F-code polling memory box.
You can check the document in the memory polling box by printing it out.
(See "Checking and clearing document data in a box" on page 56.)
When using F-code polling memory, do not set the reception mode to manual reception.
Note
Scanning a document into an F-code polling memory box
The procedure for scanning a document into an F-code polling memory box (page 81) is in general the same as
"Scanning a document into polling memory (the Public Box)" on page 38.
1
Perform steps 1 through 4 of
"Scanning a document into polling
memory (the Public Box)" (page 38).
2
Select "S.A.M-POLL ORIG" with the
[ ] or [ ] key.
PQ
DED COPY
LEX SCAN
LEX SCAN
ACC
3
Press the [OK] key.
GHI
BACK
OK
PQRS
4
Select the name of the polling memory
box with the [ ] or [ ] key.
If not all letters of the programmed name appear,
press the key to display all letters. Press the
again to return to the previous display.
About the steps that follow
See steps 6 through 10 in "Scanning a document
into polling memory (the Public Box)" (pages 38 to
39). Where "public box" (page 38) appears in the
procedure, substitute "F-code polling memory box".
SELECT READING
MEMORY POLLING
S.A.M-POLL ORIG
SEL S.A. POLL BX
Document Plan
Document Tech
- - - - - -
[#]:LIST DETAIL
key
TRANSMISSION USING F-CODES
4
55