(Mx-M182D/Mx-M202D/Mx-M232D) - Sharp MX-M202D Operation Manual

FAXING A TWO-SIDED ORIGINAL

(MX-M182D/MX-M202D/MX-M232D)

Follow the steps below to automatically transmit both sides of a two-sided original. (This is only possible on models
that have an RSPF installed.)
Do not use an original that is not a standard size (A3, B4, A4, A4R, A5, 8-1/2" x 11", 8-1/2" x 11"R (11" x 17",
Note
8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, A4, A4R if the machine uses inch-based paper sizes)).
Otherwise a scanning error or cut-off image may result.
1
Make sure that the machine is in fax
mode.
When the machine is in fax
SCAN
mode, the [FAX] key indicator is
lit. If the indicator is not on, press
LINE
FAX C
the [FAX] key. If auditing mode
DATA
S
G
F
has been enabled for the fax
function in the system settings, a
message will appear prompting
you to enter your account number when you switch to
fax mode. Enter your account number (five digits) with
the numeric keys. (See "ACCOUNT CONTROL" on
page 103.)
2
Place the original(s) in the document
feeder tray. (See "USING THE
SPF/RSPF" on page 12.)
3
Check the original size.
RATIO AUTO IMAGE OUTPUT 2-SIDED COPY
RESS FORMAT ORIGINAL SIZE DUPLEX SCAN
RESS BROADCAST ORIGINAL SIZE DUPLEX SCAN
When the [ORIGINAL SIZE] key is pressed, the size selection
screen appears. If the original size was not correctly
detected, see "MANUALLY SETTING THE SCANNING
SIZE" (page 13) and set the correct original size.
4
Press the [DUPLEX SCAN] key.
MAGE OUTPUT 2-SIDED COPY
MAT ORIGINAL SIZE DUPLEX SCAN
CAST ORIGINAL SIZE DUPLEX SCAN
The duplex mode
selection screen appears.
• Booklets and tablets
Note
Two-sided originals that are bound at the side are booklets, and two-sided originals
that are bound at the top are tablets.
• Duplex scanning is cancelled when the transmission is completed, or when the
[CA] key is pressed.
• Duplex scanning of two-sided originals is only possible when an RSPF is used. Automatic
scanning of both sides of an original is not possible when the document glass is used.
• Automatic scanning of both sides of an original longer than A3 (11" x 17") is not possible.
• The image of the back side of the original is rotated 180 degrees if needed at the time of
transmission, and thus there is no need to change the orientation at the receiving machine.
• To cancel duplex scanning, select "1-SIDED" in step 5 and then press the [OK] key.
• When duplex scanning is enabled, dual page scan (page 42) cannot be enabled.
ORIGINAL SIZE
AB
AUTO
A3
B4
DUPLEX SCAN
1-SIDED
2-SIDED
5
Select "2-SIDED" with the [ ] or [ ]
key.
PQ
DED COPY
LEX SCAN
LEX SCAN
ACC
6
Press the [OK] key.
The duplex original type
selection screen appears.
GHI
BACK
OK
PQRS
7
Select book or tablet for the duplex
original type with the [ ] or [ ] key.
8
Press the [OK] key.
You will return to the base screen and the duplex
scanning mode icon will appear.
9
Continue from step 4 of "BASIC
PROCEDURE FOR SENDING FAXES"
(page 17).
BASIC OPERATIONS
DUPLEX SCAN
1-SIDED
2-SIDED
2
DUPLEX SCAN
BOOKLET
Booklet Tablet
21